LX-100-TC industrial wireless remote control
1 technical indicators:
1.1. remote control:
The 1.1.1. button (remote control ) : 8 keys
1.1.2. mode: FSK.
1.1.3.: remote control distance of200 meters
Power supply:188.8.131.52 1.5V AA battery.
1.1.5. use of the environment temperature: -20℃ ~+50 ℃.
Waterproof grade: IP651.1.6.
1.1.7. weight:290 gram.
1.1.8. size:215x 75 x30mm
The 1.2.1. output relay: a total of 8function control relay, power on, off and7point dynamic output.
1.2.2. contact load capacity:5A250VAC,5A30VDC.
The 1.2.3. antenna: the built-in antenna, can choose an external antenna, when ordering the selected.
1.2.4. controller:36V,220V, V AC380optional, ordering the selected.
1.2.5. use of the environment temperature: -20℃ ~+50 ℃.
Waterproof grade: IP651.2.6.
1.2.7. weight:780 grams ( excluding wiring cable ).
1.2.8. size:60x 135 x203mm
2.1. mounted on the switch controlled by a remote controller, according to the" power" button, start the wireless remote control system, remote control on the indicator slow flash.
2.2. according to the need to" /Up"," /Down", and the corresponding key operation, press the button, indicator light flashes rapidly.
2.3. press the " stop" button, the main power supply system of the controlled equipment, stop working, indicator lights.
2.4. remote controller and controller configuration:
2.4.1. new factory matching remote controller and controller has completed the configuration operation, pair using a remote control device and controller need to configure operation, select the new channel, and for the controller is provided with remote control the same address.
2.4.2. open controller shell, to the controller power.
2.4.3. remove the remote control of the magnetic switch, click the settings button controller circuit board, then the controller is set on the light goes out, and then press, let go of remote control on the" power" button three times again at the same time, press the " /East"," /South" south", West / West."," North /North" four keys, the remote start controller, and the configuration process, automatically to the controller sends configuration information, the process of sending remote control indicator light flashes rapidly, the remote controller transmits light is extinguished, completing the configuration process within 20 seconds, if the controller fails to receive configuration of the transmitter signal, the controller will automatically restoring the original state.
2.5. remote controller of low voltage indication:
Electric normal ~ LED display green, remote control work
Very low power levels to LED display red, remote control to stop work, must replace the battery.
3points for attention:
3.1. operating remote control system should read the prospectus.
3.2. use the wireless remote control system of personnel, should be obtained to control corresponding equipment qualification, ensure the normal operation of equipment, in order to avoid danger.
3.3. shall ensure that the remote controller battery is enough, when the battery voltage is low when the alarm as soon as possible, to replace 1.5VAA battery ( not use1.2V rechargeable battery ).
3.4. installation or repair wireless remote control system, should shut down the system power, to avoid the risk of electric shock.
The 3.5. controller is installed, should avoid controller is metal parts are covered, from shielding phenomenon, reduction of receiving sensitivity.
The 3.6. without professional training personnel shall not open the machine, so as not to cause damage to.
3.7. system failure by professionals, repair, or contact with the agent.